I like to announce the availability of the latest video in the educational series of Amplifier Design and configuration. I demonstrate the difference between Zero Voltage switching and adjustable deadtime. While the analogue signal provision via a centre tapped transformer is simple enough to use it does however lag in tuning and the higher components count and costs. No consideration
I like to announce the availability of the latest video in the educational series of “Amplifier Design and Configuration”. I test the SG3525A IC as replacement for signal generator and Half-Bridge IC’s. It is a very low-cost solution for our standalone application we require for any energy systems including Electroculture where we want only to add a batterie to the
I like to announce the availability of the latest video in the Amplifier and Configurations series. Some time ago I tested Half-Bridge IC’s on the breadboard and compared them. I found the best Full- Bridge performance from the NCP5181 IC. We achieved at 10 Volts 11.1 KV and consumed 3.9 Watts. Now that I printed a PCB for these Half-Bridge
I have received the latest PCB versions I was taking about the last time. The Half-Bridge for the ZVS, dual Class C amplifier and the NCP5181 with Boot Strap technology. I have done testing them with two circuits and long fly wires before, now we test them on one circuit board. I did postulate that ideally the Half-Bridge should not
I like to announce the availability of the latest video in the educational series of Amplifier Design and configurations. In this video I test the RCD and the LCD snubber in regenerative mode. It is an overall overview of snubber technologies but by far not exhausted. You find the video under /research/courses/electronics-design/amplifier-design-and-configuration/. The video is only available to members.
I announce the availability of the latest video in the educational series of Amplifier Design and Configuration. I this video I look at power consumption between dual Class C “ZVS” amplifier and the Half-Bridge. You find the video under /research/courses/electronics-design/amplifier-design-and-configuration/. This video is only available to members.
I have added a new video in the latest series of Amplifier design and configuration. In this video I use two class C Amplifier boards and drive the primary of the high voltage flyback transformer. I compare the performance with the single Class C Amplifier. Do two amplifiers consume twice as much power for a given load output or is
I like to announce the availability of the latest video in the educational series. I test my first version of the Class C amplifier. The performance is very good, but I made already changes to improve the circuit. There will be a new link under diagrams and datasheets which will open a page where I will post all pcb design
I like to announce the availability of the lasted video in the educational series. In this video we look at all calculations for the half-Bridge IC like Bootstrap capacitor and RC snubber. I will then demonstrate the result on the circuit and the response to the component selection. I will also introduce a new circuit board I designed containing all
I like to announce the availability of a new video in the educational series. While I have to wait for orders to arrive, I wanted to pick up on a pressing subject effecting everybody. The problem to get your amplifier running without failing. I have created a new menu point in courses under research and electronic designs. The link is