I like to announce the availability of the latest video in the Asymmetrical design series with SMPS transformer. In this video I demonstrate the generic design of an inverter to the asymmetrical design. I charge 2, 1000 uF 450 Volt capacitor up to 300 Volts. Across each capacitor is a break resistor. At 300 Volts a minimum of 9 Watts
I just released a video on YouTube to reach more viewers as this is now very important. I design a detailed testing script for the pancake coils and drive a 100 Ohms load. Every aspect of power delivery is measured and calculated including the testing of the equipment based on the simulation. For those of who want to take that
I have released a new video with the subject of asymmetrical coils alignment. This time I take the scalar network under this configuration. Many experiments I conducted in the past were in fact showing unusual results when the coils or components were asymmetrical aligned. The videos from the scalar network I produced did follow the instructions from the Book of
I like to announce the availability of the latest video in the Dielectric Field Propagation series. In this video I use 4 fluorescent light bulbs in parallel with the vacuum tube and in series. I also use capacitance and get a very good performance which does avoid the latching up. You find the video under /movies/dielectric-field-propagation/. Non-Members and Basic Members
I like to announce the availability of the latest video in the Dielectric Field Propagation series. In this video I start using vacuum equipment for testing plasma behaviour I purchased 10 Years ago when I was conducting plasma experiments on YouTube. I replicate the Avramenko experiment in addition with the transparent glass column with various pressure levels. The result is
I like to announce the availability of the latest video in the Dielectric Fields Propagation series. In this video I replaced the last set of toroid coils with bifilar pancake coils. It shows some interesting effects. We measure the light intensity because the voltage drops as over frequency is not reliable anymore as measurement for power. A second set of
I like to announce the availability of the latest video in the Dielectric Field Propagation series. Looking for ways to improve power delivery in the LMD network I stumbled upon the Avramenko plug when revisiting research material. While this plug is very well understood the radiant energy component is not. Looking the way all gas filled tubes produce light it
I like to announce the availability of the latest video in the Dielectric Fields Propagation series. Here I expanded the LMD network to two networks as one module and drive with the ZVS half-Bridge. I also removed unnecessary wiring and components. The result is we get more output for the same power input. You find the video under /movies/dielectric-field-propagation/. Basic
I like to announce the availability of the latest video in the Dielectric Field Propagation series. I made many changes including the exchange of the ferrite rods with toroid cores. I will also demonstrate the losses a diode in the circuit from the amplifier produces. You find the video under /movies/dielectric-field-propagation/. Basic Members and Non-Members can purchase the video.
I like to announce the availability of the latest video in the Dielectric Field Propagation series. I made changes to the circuit to allow for tuning of impedance and inductance and gained valuable information for further improving. Goal is to consume as little as possible from the voltage source and deliver as much as possible to the load. We had