I like to announce the availability of the latest video in the educational series of Amplifier Design and configurations. In this video I test the RCD and the LCD snubber in regenerative mode. It is an overall overview of snubber technologies but by far not exhausted. You find the video under /research/courses/electronics-design/amplifier-design-and-configuration/. The video is only available to members.
I announce the availability of the latest video in the educational series of Amplifier Design and Configuration. I this video I look at power consumption between dual Class C “ZVS” amplifier and the Half-Bridge. You find the video under /research/courses/electronics-design/amplifier-design-and-configuration/. This video is only available to members.
I have added a new video in the latest series of Amplifier design and configuration. In this video I use two class C Amplifier boards and drive the primary of the high voltage flyback transformer. I compare the performance with the single Class C Amplifier. Do two amplifiers consume twice as much power for a given load output or is
I like to announce the availability of the latest video in the Amplifier design and configuration series. In this video I test and demonstrate the updated version 1.1 of the Class C amplifier. In this design I added a Gate Cap terminal which is removing spikes from the gate without the current draw and even more by reducing the overall power
I like to announce the availability of the latest video in the educational series. I test my first version of the Class C amplifier. The performance is very good, but I made already changes to improve the circuit. There will be a new link under diagrams and datasheets which will open a page where I will post all pcb design
I like to announce the availability of the latest video in the Electrolysis series. I received my manufactured plates for the Dry-Cell I wanted to build. I compare the purchased 21 Plates with the prototype 47 plates. The dimension of my plates is 12 X 12 cm versus the purchased one of 10 X 10 cm. Both dry-Cells are connected
I like to announce the availability of the lasted video in the educational series. In this video we look at all calculations for the half-Bridge IC like Bootstrap capacitor and RC snubber. I will then demonstrate the result on the circuit and the response to the component selection. I will also introduce a new circuit board I designed containing all
I like to announce the availability of a new video in the educational series. While I have to wait for orders to arrive, I wanted to pick up on a pressing subject effecting everybody. The problem to get your amplifier running without failing. I have created a new menu point in courses under research and electronic designs. The link is
I like to announce the availability of the latest video in the LENRs series. In this video I go through great length to understand and replicate what we have seen in “Step one”. I did build a new Stanley Meyer tube module with three tubes and one centre rod. I also try to ignite two lanthanated cathode rods. This video
I like to announce the availability of the latest video in the LENRS series. In this video I have applied some changes and will see if these improvements are beneficial. You find the video under /movies/low-energy-nuclear-reactions/. Non – Members and Basic Members can purchase the video.